9/13/2016

Will Digiprog 3 change mileage on Mercedes W212?

I want to correct mileage on my W212 2013 year. Is only way to use MB CAN Filter?  I found some tutorial in carprog but doesn’t show steps with the mileage adjust. For example, if install mb can filter, do you still update ezs odometer value or just cluster? Yes I know AVDI Abrites original does it all, before you tell me, but can’t afford that software yet.
Anywhere else have to change it? Tire pressure sensors of transmission?
Thank you in advance.

Customer solutions:
1.Late 2013 Mercedes W212 you need to correct odometer and install CAN Filter (EZS nothing).The can filter goes near the cluster. I have done with Yanhua Digimaster 3. It is not cheap. But I think at you can use digiprog 3. By the way, take backup from eeprom first.

2. If it is full color dashboard, digiprog 3 cant do it..
If it’s not facelift model (so before 2013) and use digiprog 3 v4.94, then you don’t need can filter/blocker.
But a can blocker is better to use all times, because if dealer reads the EZS it shows same mileage as in tacho, if you dont use can blocker then EZS shows 999999km.. (but normally dealers don’t read EZS, they only read ‘assyst manager’ when serviced).
To change mileage you need to use option ‘EZS’ in menu of mercedes w212 of digiprog III.. then it blocks ezs and changes tacho automatically.
If you roll back odometer to a lower mileage off last service, its best to delete service history in car. use option ‘assyst manager’. enter ‘744’ days and ‘25000’kms for next service warning, and press ‘V’ when it asks to delete service history.
When you have a diesel it probably gives DPF error in car. and the car will run in emergency-mode, only drives max 80kmh. digiprog can’t reset this. You have to go to dealer or someone else who can reset dpf.
When some other errors turn up in display use the ‘clr error’ option to reset.

9/05/2016

Nissan Navara PDF BDM to Digiprog 3 ST48

Can someone help me to get PDF for this pickup Nissan Navara year is October 2013 and inside is 9S12 processor, i have Digiprog 3 odometer correction master but no pdf i send foto.
Nissan Navara cluster 1
Nissan Navara cluster 2

photos too fuzzy.
pinout-foto-1
pinout-foto-2
this is what I have for connections Nissan Navara 2014
connections Nissan Navara 2014
these are the points of connection for digiprog 3 v 4.88
using cable 48
greetings reports.
cable 48
in menu digiprog go to nissan navara 9s12

ST48 colors and pinout and tips on 9s12 processors. Find the ground at it should be easy to figure out if it has the 6 pads or 6 pins.
ST48 pinout

Almost all clusters with 9s12 Processors have this setup, a quick way to program almost any digital odometer with a 9s12 processor.

I have had good success using ST48 and the MCU function from Eeprom menu of Digiprog3.  See example picture, a lot of times the two unused pads have no solder bump on them, a clue to the orientation.  Sometimes access is from the other side of the board and the contact points would be reversed like below.
Reversed contact point layout
Reversed contact point layout 
9s12 Processors pinout