4/20/2016

Ford Expedition 2003 mileage change with Digiprog 3

Has anyone used the Digiprog 3 v4.94 on a 2003 Ford Expedition? I'm not sure what cable to use or the correct connection points.


Solution:

Several boards were in those clusters Digiprog iii will work most of them were hc912 mcus.
Digiprog will do them whether your writing them manually by hand or with another calc built into digi
if its a hc11 it will also work


Ford Expedition 2013 dash pictures attached:

ford-expedition-dash
ford-expedition-dash-2

 the processor in that board is a hc912d60 mcu board

and according to tachosoft these are the mileage blocks

Car type: Ford Expedition - 68HC912D60 - 2003 year
The mileage is stored in the next lines:
0340: 4A 38 xx xx xx xx xx xx xx xx xx xx xx xx xx xx
0350: 4A 38 xx xx xx xx xx xx xx xx xx xx xx xx xx xx
0360: 4A 38 xx xx xx xx xx xx xx xx xx xx xx xx xx xx
0370: 4A 38 xx xx xx xx xx xx xx xx xx xx xx xx xx xx
0380: 4A 38 xx xx xx xx xx xx xx xx xx xx xx xx xx xx
where the next bytes:
4A 38 - is a mileage

Try this connection.
digiprog-3-ford-expedition

yes thats what you needed for wiring under digiprog3
goto eeprom
then page down to mcu
then select 9s12 and 9s12 4k
i believe its the 4k you need for d60
use ST48 which is 5volt St51 is 12volt when powering board instead of just mcu

wire how clusters pic is which is your life saver knowing where to grab reset on board
then handwrite mileage block

or make your life alot easier and order a usaprog or datasmart dsp3 something else
but digiprog will do as well.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.