I need help with a 2004 Ford F350 super duty cluster mileage correction. I’m using digiprog 3 v4.94 but i don’t have the diagram or what chip looking for to extract the info from this cluster. So I searched and find some documents.
What is needed plug 51.
FORD VAN F350
Remove the cluster and it.
Connect shown in the photo’s below the plug 51 with the
marked soldering points. The white marked soldering points among themselves
and connect to the white wire from St. 51st (Photos s. Next page)
Select the program: cars / trucks – FORD – F350.
The DIGIPROG denotes old / incorrect Mileage.
program and completed the new / correct Mileage.
FORD VAN F350
Remove the cluster and it.
Connect shown in the photo’s below the plug 51 with the
marked soldering points. The white marked soldering points among themselves
and connect to the white wire from St. 51st (Photos s. Next page)
Select the program: cars / trucks – FORD – F350.
The DIGIPROG denotes old / incorrect Mileage.
program and completed the new / correct Mileage.
But my cluster looks different from the pic in the manual, here is mine.
Then a DigiProg expert pointed me the proper solution.
Use the BDM points mate 4 wires
Do like in clusters picture. use connector ST48 and wire to the 6 pin point pad and read thru ford f350 or thru eeprom programmer set to mcu 912 4k.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.