9/05/2016

Nissan Navara PDF BDM to Digiprog 3 ST48

Can someone help me to get PDF for this pickup Nissan Navara year is October 2013 and inside is 9S12 processor, i have Digiprog 3 odometer correction master but no pdf i send foto.
Nissan Navara cluster 1
Nissan Navara cluster 2

photos too fuzzy.
pinout-foto-1
pinout-foto-2
this is what I have for connections Nissan Navara 2014
connections Nissan Navara 2014
these are the points of connection for digiprog 3 v 4.88
using cable 48
greetings reports.
cable 48
in menu digiprog go to nissan navara 9s12

ST48 colors and pinout and tips on 9s12 processors. Find the ground at it should be easy to figure out if it has the 6 pads or 6 pins.
ST48 pinout

Almost all clusters with 9s12 Processors have this setup, a quick way to program almost any digital odometer with a 9s12 processor.

I have had good success using ST48 and the MCU function from Eeprom menu of Digiprog3.  See example picture, a lot of times the two unused pads have no solder bump on them, a clue to the orientation.  Sometimes access is from the other side of the board and the contact points would be reversed like below.
Reversed contact point layout
Reversed contact point layout 
9s12 Processors pinout

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.